[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[at-l] Re: AT-L digest, Vol 1 #470 - 40 msgs
- Subject: [at-l] Re: AT-L digest, Vol 1 #470 - 40 msgs
- From: FLATers@webtv.net (FLATers@webtv.net)
- Date: Sat, 27 Oct 2001 20:21:55 -0400 (EDT)
- In-Reply-To: at-l-request@mailman.backcountry.net's message of Sat, 27 Oct2001 12:03:11 -0500 (CDT)
WOW....... now where did I put my 3D glasses? I can't read this! LOL
Landslide
previously posted <<<<<
Use a sharp knife or box = cutter.
Later you will bend these tabs inward to act as a support and also as =
air
intake.
top
of can> =
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
outlets 1-1/4"x3/16" > ::::::::: :::::::::
:::::::::
wire
mesh> xxxxxxxxxxxxxxxxxxxxxxxxxx
inlets/support tabs > [_] [_]
[_]
bottom
of can> =
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D Cut a
circular piece of (1/16" interstices) hardware cloth (screen wire) =
1/4" wider diameter than the diameter of the can, for added strength, =
fold
in and crimp the edges under tightly to the size of the inside of the =
can.>>>>>>>>>>>>>>